Start Ableton then Serto. Make sure you have it enabled, in serato go to settings, then pluggins and make sure The Bride is checked. With both programs running it will ask to authorize The Bridge. To authorize you will also need a internet connection.

Hey DJMikeyD73,

As DJ T-Rev said, make sure you have 'enabled the Bridge' in the Plugins tab of the Scratch Live setup screen. Now run both programs and an authorization window should appear in Ableton - and then the Ableton tab should appear in Scratch Live.

Let me know if you have any problems with this :)

I have the 2.1.1 software installled and the the 8.2 version of Live 8 but in the plugins section of Scratch it's not showing up? both pieces of software are authorised

Just making sure I'm registered here - I tried to add/edit registered products (my SL3) to my profile here on Serato - doesn't seem to update the page for me to view?
Can ya tell me if it is registered?

A step by step guide would be helpful when syncing up the two pieces of software!

I was working fine with the bridge, but tonight have just upgraded my SL3 driver to v2.31 and downloaded the release candidate 1 on 2.2.0 - Now I've lost the ableton tab and option in the setup screen? If i revert to previous version of scratch live still no luck!

Ableton tells me audio is disabled, and the SL3 option does not show up, only the core audio and built in output.

If i go to system preferences the SL3 is not showing up either?

Hey Chris LP,

I can't see anything registered to your profile, you need to register here : www.serato.com

With your Bridge issue, when you go to the Plugins tab of the Setup screen is there NO 'enable The Bridge' option?? If not, can you look at the bottom left corner of the setup screen to double check you are using version 2.1.1. Let me know :)
----------------

Hey AlixxJ,

Would you be able to start a new help thread, I'm not too sure what happened here we will need to ask you a few questions which will be easier / tidier in your own thread ;)