This is a feature that I would like to request, and hope will be added. When I select my FX everything saves as it should except for the FX parameters . Every time I shut down my serato and start it back up again all my fx are there, but the knobs are turned back to 0 by default for each fx. This slows me down and I have to retest all the parameters until it's just right and the way i want it. It is time consuming especially when setting up for a gig. I would like to request that when I save the FX the knob is set also to where I left it. That way I don't have to test anything and start playing and know when I use the FX my desired results will happen the way I programmed it. Nothing worst then going to a get and spend hours setting up then you have to set your FX parameters and test it to see if it comes up to the desired results smh. If I can turn on my serato and my fx parameters just there that would be soooo beneficial. Thank you very much.