Probably in the manual:

Adjusting the sensitivity of the jog dial’s touch sensor

This unit is equipped with a mode for adjusting the sensitivity of the jog dial’s touch
sensor.

The value set in the jog dial sensitivity adjustment mode is retained even when
this unit’s power is turned off.

The sensitivity of the left and right jog dials can be adjusted separately.
The example below describes the procedure for adjusting the sensitivity of the left
jog dial.

1 Connect this unit to your computer via an included USB
cable.

2 Press the [DECK1] or [DECK3] button while pressing the
[SHIFT] button.
The sensitivity adjustment mode is set, and the current sensitivity is displayed on the
indicator in the center area of the jog dial. When in the sensitivity adjustment mode, perform the next operation within 3 seconds. (If more than 3 seconds pass after a button was pressed, the set value is stored and the indicator returns to the normal display.)

3 Press the [DECK1] or [DECK3] button while pressing the [SHIFT] button. The sensitivity increases each time the [DECK1] button is pressed and decreases each time the [DECK3] button is pressed. When the jog dial’s sensitivity is adjusted, the set sensitivity is displayed on the indicator in the center area of the jog dial. Low sensitivity (–10) No adjustment (±0) High sensitivity (+10)

The jog dial’s sensitivity can be adjusted in 37 steps.
- The default setting is “No adjustment (±0)”.
- To adjust the sensitivity of the jog dial on the right side, press the [DECK2] or [DECK4] button while pressing the [SHIFT] button.

4 - Once the setting is completed, wait as such for 3 seconds.
When 3 seconds have passed after a button was pressed, the set value is stored and
the indicator returns to the normal display.



YUP it was in the manual:pioneerdj.com