DJing Discussion

Forum
 DJing Discussion
HELP ..
This area is for discussion about DJing in general. Please remember the community rules when posting and try to be polite and inclusive.

HELP ..

groovesection 8:10 PM - 25 September, 2007
i went away for the weekend and when i came back i went to turn on my mixer and i powered up fine then i started hearing a high pitch hum i made sure the wires were plugged in and then saw spots on my mixer like fluid was spilt on it i unplugged it and opened it and found fluid did get into my mixer ....now i dont know who did it but WTF>>>>what do i do how do i clean it or am i just !@%&!%#@&^# please i have it apart right now what w;ould be the best way to take care of this ....
DJ Cykophuk 9:56 PM - 25 September, 2007
it 'may' have fried when you turned it on wet. If that happened to me, I would pull it apart, let it dry, maybe spray it with arosol alcohol to help to displace the moisture. I'd keep it someplace warm and dry for a day or two at least...maybe a week.

This is not advice, its just "what I would do".

good luck.
ImShifty 5:59 AM - 26 September, 2007
damn dood, that sucks, hope your baby's fine
groovesection 7:02 AM - 27 September, 2007
whoa...i took it apart and i poured a big bottle of alcohol all over the board that got wet...and alcohol cleaned a the small areas that has fluid on it and its like brand new...everyting is in top working condition ...thanks for the post ...and my rane is brand new now!!!
DJ Cykophuk 12:15 PM - 27 September, 2007
awesome!