Lightning
7:28 PM - 10 November, 2012
Thats fine, lets say you wanted to make a build up 8 bars before bar 59 dropped for example. The you wanted to shuffle the roll around until your done and then drop. You can't do it cause its ALWAYS in Slip mode.
You can kind of do this with a normal loop but then you are restricted to halving or doubling the loop in set increments in either direction. Not the same effect!
It should work like the slicer where you can can grab a set measure and lock into measure until your done. Slip and Locked.
The other thing I will add, since the Loop Shift and the 1/2X and 2X are the same buttons. makes it a little awkward to 1/2 the shift forward to build a progressively building loop roll up. So far the only thing I see the roll function being good for is glitching and small but very brief rolls.
