DJing Discussion
Can i record straight to my DAW post fader channel 1 and 2
This area is for discussion about DJing in general. Please remember the community rules when posting and try to be polite and inclusive.
Can i record straight to my DAW post fader channel 1 and 2
djdsk
11:50 AM - 13 October, 2009
HI im close to getting a tt57 i think so i wanna check this first , does the tt57 when connected by usb show up as a 2 channel card . SO i can record channel 1 to track 1 and channel 2 to track 2 ?
Thanks in advance
Thanks in advance
wrosenbl12
1:42 AM - 14 October, 2009
from what i understand the 57 isn't able to support multi-track recording.
Shaun W
6:41 PM - 14 October, 2009
If you're using a Mac you can create an aggregate audio device for multi-track recording.
Here's how -->> www.apple.com
Here's how -->> www.apple.com
wrosenbl12
1:57 AM - 15 October, 2009
thanks shaun that's good to know! i'll have to consider gettin a mac.
djdsk
10:45 AM - 17 October, 2009
Great so Shaun after setting up , i can Logic select track 1 input as channel 1 and rack 2 input as channel 2 , they wil both record post fader is that correct ?
So i could play an instrumental scratch over it and the scratch would come out on a separate channel post fader ?
thanks
So i could play an instrumental scratch over it and the scratch would come out on a separate channel post fader ?
thanks
Shaun W
6:11 PM - 21 October, 2009
I'm not familiar with Logic, but yes, both channels stream post fader :)
Yes, PGM 1 would go to USB 1 and PGM 2 would go USB 2
Quote:
Great so Shaun after setting up , i can Logic select track 1 input as channel 1 and rack 2 input as channel 2 , they wil both record post fader is that correct ?I'm not familiar with Logic, but yes, both channels stream post fader :)
Quote:
So i could play an instrumental scratch over it and the scratch would come out on a separate channel post fader ?Yes, PGM 1 would go to USB 1 and PGM 2 would go USB 2
nik39
9:05 PM - 22 October, 2009
Make sure you use the rane recording utility to setup PGM1+2 to your desired source (post fader).
To participate in this forum discussion please log in to your Serato account.