Serato DJ Pro General Discussion

Talk about Serato DJ Pro, expansion packs and supported hardware

Club pack upgrade dumb question

Guy Morris 3:36 PM - 11 December, 2017
Hi all

Following on from a previous post regarding HID and NXS2 units I understand I will need to purchase the club pack to use the 900 mixer usb set up. As I'm in a busy time I just want to make sure that there are no issues with upgrading my current serato DJ software that could leave me without my play out system

Is it just a matter of going into 'my serato ' and purchasing the upgrade and doing the software download?
Will all my record cases and cue points etc remain the same? (only just re-sorted them all after a hard drive fail)

I have backed up the library and have the serato file showing on the back up drive
I have upgraded the DJM 900 nxs2 firmware as of 11/12/2017
I have upgraded the 2000 nxs2 firmware as of 11/12/2017
I am currently on a Mac osx running 1.10

I know this is all pretty obvious but!!!!!! Just want to make sure as I have always been wary of doing upgrades and having stuff fail

raedonquan 6:25 PM - 11 December, 2017
Once you get the clubkit nothing changes it just gives you the possibility to run every serato device without worrying..

Make sure all the pionneer gear firmware is updated...

Once you plug in the djm-900n2 the software will ask you to install the driver.. just install and it should unlock

You also may need to setup the utility of the djm-900