DJing Discussion
pelican case
This area is for discussion about DJing in general. Please remember the community rules when posting and try to be polite and inclusive.
pelican case
DJCASE
11:09 PM - 4 November, 2009
I just got the rane pelican case for the 57, and noticed that it applies a LOT of pressure on the faceplate & knobs of the mixer. Does anyone from Rane know if this could this have some negative impact in the long??
Thanks.
Thanks.
DJ Dill Pickle
11:38 AM - 5 November, 2009
My two cents = No.
Mine's been in it for yeeeears, has huge impression in the foam where the knobs are and still runs well.
Mine's been in it for yeeeears, has huge impression in the foam where the knobs are and still runs well.
nik39
11:02 AM - 9 November, 2009
Thanks.
You should repost in the help section to get an official answer.
Quote:
I just got the rane pelican case for the 57, and noticed that it applies a LOT of pressure on the faceplate & knobs of the mixer. Does anyone from Rane know if this could this have some negative impact in the long??Thanks.
You should repost in the help section to get an official answer.
O.B.1
5:22 PM - 10 November, 2009
I noticed this as well, but have had no issues.
Once, it fell off a sub during transport but due to the tight fitting case, the mixer was fine...
Once, it fell off a sub during transport but due to the tight fitting case, the mixer was fine...
To participate in this forum discussion please log in to your Serato account.